Notes on Non-automated Treatment of Waste Metal Precision Stamping Parts

In the production of metal precision stamping, because stamping parts are mass-produced, a lot of waste is generated, and the processing of these Metal Stamping waste is a particularly dangerous task. It is best to use automated equipment for processing, although there are also many wastes that have to be handled manually.

Then let‘s talk about the safety measures for non-automated processing of metal stamping parts waste:

1. When discharging waste from small holes, it is necessary to automatically layer and break the waste, and at least 100 pieces of waste should be stored at the upper or lower die base. If two local waste materials are collected together, there should be enough space for stacking.

2. It is best not to deal with waste with sharp corners or burrs to avoid harming people, and to cut the waste when the size should be appropriate to avoid harming the operator when the operator is in the vicinity; 3. When the waste passes through the pipeline, we should pay attention that if the width and height of the straight line are not allowed, it is easy to cause blockage, and try to avoid passing more than two kinds of waste on one pipeline.

4. The chute for removing waste must be connected to the end of the backing plate and aligned with the mouth of the waste pit. When installing the chute, pay attention to whether the screws of the hardware precision stamping die are tightened.

5. If the waste cannot fall by its own weight, once it is hung at the edge, it should be forced to fall by throwing, ejecting and other falling equipment.

6. In order to ensure safety, a protective cover should be installed when processing metal stamping parts waste in the vicinity without automation, and the waste should not be allowed to flow out or fly away near the operator during operation.

This article is from EMAR Mold Co., Ltd. For more EMAR related information, please click: www.sjt-ic.com,