Clave technicalitatis processionis pulseris est allocatio production is et seleccio variorum parametrorum principium. Yiwei Precision has been engaged in customized processing of stamping parts for more than 10 years, accumulating rich experience. Post annos summarizationis sumus sequentes standardes technical et parametros principes referentiae tuae.

1. Selection instrumenti. Omnium criterium ad seleccionem instrumentorum succidendum est development economia. Under the standards of production and processing regulations, the tool suspension depth should be as short as possible, and the CNC blade diameter should be as large as possible, which is beneficial for reducing the surface roughness of production and processing, and developing the rigidity, heat dissipation and tool service life of the tool system software. However, it should be noted that the half radius of the tool for rear clearance should be lower than the small angle of the wheel profile.

2. Selection of lathe. Adopting a lathe system software with good rigidity and high precision, including a closed loop control servo control system.

3. Assignatio fluxum procedentium. Post calorem tractionem extinguentis, superdifficile productionem et processionem procedentis fluctus profundum processionem proficis et semi profundum processionem extinguentis extinguentis, secundum fertilem tractionem ut solverem problemam, et tunc superdifficile productionem et processionem extinguentis per lathe exercitur.

4. Totum latitudinem palli. Tota latitudine inferioris mortis rubris non est necesse praeterire 25mm, totam latitudinem exterioris mortis rubris non est necesse praeterire 20mm, et totam latitudinem interioris mortis rubris non superest 15mm. Si totum latitudinem anguli superest hoc valorem, antequam calefacis calefacis molatur retrorsum.

5. Capacitate orali. The remaining amount of pre embedded machining after semi deep processing of the cutting edge is 0.2-0.3 millimeters (taking into account the deformation caused by heat treatment and quencing), which means that the production output of superhard production machining after cutting edge heat treatment should be 0.1-0.3 millimeters. Excessive exchange of production capacity can harm machining accuracy and aggravate the wear of CNC blades. If the capacity is too small, there is a high possibility of material shortage during heat treatment deformation.

6. Fuga strength. Fortitudo gladii post therapiam caloris circa HRC55-65 est.