Numerical control machining is very active in various fields, including aerospace, medical, automotive, intelligent equipment, daily necessities, and other industries. However, numerical control machining uses heavy equipment, and a slight lack of attention can lead to serious consequences. Quid ergo causae errorum mechanicae processionis sunt?

1. Factores humanos

(1) Lacrimus concentration is: Quando attention operatoris non focus est, potest causare errores inutiles, et in cases graves, instrumentum machinae et securitatem vitae peribit.

(2) Misunderstanding: Incompleta intellegentia operatoris frame processionis facile potest errores processi.

(3) Error initoris: a causa lack of experience, novice operators are prone to mechanical processing error s.

(4) Unexpected error: Mechanical processing errors caused by some abnormal situations, such as component failures in processing equipment, detachment during fixture processing, etc.

(5) Intentional errore: Error hominis intentionis operatoris causae a quibus rationibus personibus negativa est.

2. Programming error

(1) Focus coordinationum est 0, sed in acto processo summum est 0.

(2) The safety height is too low, and the tool cannot fully lift the workpiece.

(3) The secondary opening has less clearance than the previous one.

(4) Post completionem programae, analyzate et verificate viam programmae.

3. Program manifest remark error

(1) Scribe numerum contactorum in una latere sicut centrum quattuor laterum.

(2) Monstratio distantiae clampionis caliper is aut distantiae protrusionis opus est incorrecta.

(3) When the length annotation of the tool ejection is unclear or incorrect, it may cause contact.

(4) Lista programarum tam detalior quam possibile esse.

(5) When changing a single assembly, the new exchange principle of discarding old programs must be adopted.

4. Tool measurement error

(1) Entrata datum instrumentorum non considerat tenentem instrumentum.

(2) The tool installation is too short.

(3) Tool measurement adopts scientific methods and strives to use precise instruments.

(4) Longitudo cultri 2-5mm longior est quam altitudo facta.

5. Error transmissionis programmae

(1) Numero programae incorrecta vocatur, aut in programma varia est, sed a veterino programa processum est.

(2) The on-site contractor should check the detailed data of the program before processing.

During CNC Machining, due to human or machine tool reasons, tools or tool holders are prone to collide with workpieces or machine tools. Mild cases can cause collisions between tools or machined parts, while severe cases can damage machine tool parts, causing the machine tool to lose machining accuracy and even causing personal safety accidents. Therefore, familiare se with the causes of CNC machining errors before performing CNC machining can help reduce the occurrence of errors, reduce CNC machining accidents, and improve the safety rate of CNC machining.