Nequam importat quibus produktis aut quibus tecnicus nostri per stampionem processant, quibus ad alios problemas attention oportet. Hoc utile erit operatione nostrae et processione. Stamping processionem est aequa. Ut, quibus problemis debemus attention in tempore stampionis metallorum?

1. Scratches on stamped parts: The main reason for scratches on parts is sharp scratches on the mold or metal dust falling in the mold. Preventive measures include grinding the scratches on the mold and removing metal dust.

2. Bottom cracking of stamped parts: The main reason for bottom cracking of parts is poor plasticity of the material or excessive compression of the mold edge ring. Preventive measures include replacing materials with better plasticity or loosening the edge ring.

3. Wrinkles on the side wall of stamped parts: The main reason for wrinkles on the side wall of parts is insufficient material thickness (thinner than the minimum allowable thickness) or eccentricity during the installation of upper and lower molds, resulting in a large gap on one side and a small gap on the other side. Preventive measures include immediate replacement of materials and readjustment of molds.