Metodo rotationis est paris cutores discorum contra orientationes rotationis quae secant metallum lapidem. Segundum instrumentum discorum, in tres modis divisum potest: Equatoria recta, Equatoria recta inclinata, et Equatoria inclinata. The straight equipment is suitable for cutting sheet metal in strips or square billets in round billets in Shenyang Sheet Metal Processing, the oblique straight equipment is suitable for cutting round billets or circular internal holes, and the oblique equipment is suitable for cutting billets summarized by any curve.

1. Diagonal equipment for cutting sheet metal. Diagonal equipment cutting is the most widely used in cutting metal sheets. Before cutting the sheet metal, the upper and lower rolling cutters are installed diagonally, and the angle between the upper and lower rolling cutters is set to 25 degrees. Then adjust the speed and the clearance between the rolling blades based on the thickness of the sheet metal.

2. Directly equip to cut sheet metal. When using straight equipment to cut sheet metal, first install the upper and lower rolling cutters with their straight centerlines aligned, and the gap between the upper and lower cutting blades is generally 0.05-0.5mm, or set the upper and lower rolling cutters in a slightly stacked state, so that the stacking height is generally only 0.2-0.3 times the thickness of the cutting plate.

3. Exactionem magnitudinis equipment inclinatorum secant. Cum curva caloris caloris ad summarizationem utilizat, constrainti sunt super radium curvatoris vacuum, et radius curvatoris minimus eius relatus est ad diameter anguli succidentis et dimidiae densitatis materiae. In addition, quando curvatoris caloris curvatoris ad secendum lineas rectas utilizatur, constrainti sunt etiam super errorem minimam latitudinis eius.

Contenium artificis ab internet est. Si quaestiones habes, contacta me ut deleam illum!