Velocitate cultris albi caulium non est nimis celeriter.

Laboratores copiarum minus cultros albos ad succidendum et plures cultros volantes aut cultros saltos utilizat.

When the work is too high, it should be cut thicker with different lengths of cultres in layers.

Post difficile cultro magno sequente, cultrum parum ut auferat reliquias materiae et assecurare quod remanserunt quantum prior sequentem convenit.

Simple cutting is used for flat application, with less use of ball cutters to reduce processing time.

When copper workers clean corners, first check the size of the R in the corner, and then determine what size of balloon knife to use.

quattuor anguli superficie scholae nivel habere debent.

Where the slope is an integer, use a slope knife for processing, such as pipe positioning.

Before doing each process, think carefully about the remaining allowance after the previous process to prevent excessive machining with empty knives.

Probate ut simplices currus acciperent, sicut forma, fodimentur, singulam laterem, et evitat circa altum circuitum.

When walking WCUT, if you can walk FINISH, don‘t walk ROUGN.

When cutting the shape, first roughed and then polish, and lifting the work, first polish the edge and then polish the bottom.

Reasonably set tolerances to balance machining accuracy and computer calculation time. Cum difficile secitur, tolerantia 1/5 fructus posita est, et cum dulce secitur, tolerantia 0.01 posita est.

14. Plus procedurae faciunt ut vacuum time reducatis. Considere plus et reduce probabilitates errorum facere. Adde plus auxiliarum lineas et superficies ut meliorem condicionem machinationis.

15. Quando non flata surficie militant, plures et minus concidientes, et nolite timere succidere.

16. Purge angulos cum cultro parvo et cultro magno purge.

17. Nolite timere patching, patching appropriately potest meliorare procedentiam velocitatem et decoratificare effectum processionis.

18. Alta fortitudo raw materialum: Reverse milling melior est.

19. Low hardness of raw materials: good for forward milling.

20. Instrumenta machinae habent bona precision, rigiditate, et machina precisio: magis adequata est pro forward milling, et vice versa, magis adequata est reverso milling.