Some Metal Stamping parts factories will provide sheet metal production services, with a higher comprehensive level and a wider processing range, which is conducive to improving their overall strength. In practical work, guidance on improving operational standards based on different workflow processes can enhance employees' work efficiency.

When working with workpieces in a metal stamping factory, it is necessary to hold larger workpieces with both hands, while smaller workpieces can be held with one hand.

When bending a workpiece with a small width and a large bending length, the operator stands on one side of the workpiece, and the front end of the workpiece is pressed by the left hand near the lower mold position. The right hand pushes the workpiece forward and stabilizes it. When bending, the right hand should hold the workpiece upward and move it together. When bending, the right hand should pull the workpiece upward to prevent deformation; When the bending width of the workpiece is large, the operator should stand behind the workpiece, use both hands to push the workpiece forward, and move it upward together with the workpiece during forming.

3. When bending small sheet metal parts, the operators of the metal stamping parts factory should use their fingers to hold the workpiece against the lower mold, and should not push the workpiece forward to prevent finger injury caused by the knife pressing.

When the workpiece is bent, the operator holds the upper surface of the workpiece with their thumb, and the other four fingers can move the workpiece upward to prevent the die from pressing the fingers.

When the workpiece is bent, fingers should be avoided from being placed on the surface of the lower mold.

6. The force pushing the workpiece should not be too strong to avoid sliding between the mold when the fingers and workpiece bend.

7. For the downward moving folding bed, during the upward movement of the worktable, the handheld workpiece should rise synchronously with the worktable to prevent tilting.

After bending, the workpiece should be removed by hand, and there should be no collision between the workpiece and the mold.

When bending, use a double V-shaped mold and do not press the mold down with your hands, especially for molds that are 100 mm long.

10. When operating handheld workpieces in metal stamping parts factories, it is necessary to ensure the folding balance of the sheet metal parts on both sides.