Chassis cabinets are the most commonly used field of Sheet Metal Processing, electronic chassis cabinets, server chassis cabinets, etc. Non-standard cabinet customization is a sheet metal processing manufacturer for more than ten years, with rich production and processing experience to provide customers with a variety of chassis and cabinet products. Chassis cabinets will inevitably have dust entering in daily use. The consequences of this dust problem vary in size. The most serious may lead to the paralysis of equipment, especially electronic chassis cabinets. Everyone knows that the working environment required by electronic equipment is relatively high, and a single grain of dust may cause the entire equipment to malfunction, with serious consequences. Therefore, it is very important to do a good job of cleaning the electronic chassis and cabinet. To clean the inside of the chassis cabinet, it is best to disassemble each component into eight pieces, and remove each board and clean it separately. For the board, cleaning is mainly to remove dust. Use a soft brush and a blowing skin bag to carry out this process. This process is very simple and will not be described in detail. It is important to remind everyone that you should not use too much force to remove dust with a brush, and be careful of the components on the board. For parts that cannot be reached by the brush, such as the inside of the heat sink, use a blowing skin bag to complete the cleaning. Some people feel that this is more troublesome. It is unrealistic to prevent dust from entering the chassis and cabinet, because it needs to dissipate heat externally, and each fan exchanges air externally. It is inevitable that dust will enter. It is best to keep the room clean and remove dust regularly.